Commands › Exchange Online

Clear-MobileDevice

Exchange Online ExchangeOnlineManagement Clear-*

Delete all data from a mobile phone. This action is often called a remote device wipe.

Quick start script

# Clear-MobileDevice — quick start (serv365.ai)
# 1. Connect (app-only shown; interactive: omit the certificate parameters)
Connect-ExchangeOnline -CertificateThumbprint $thumb -AppId $appId -Organization $org

# 2. Run and inspect
Clear-MobileDevice -Identity <MobileDeviceIdParameter> | Format-List

# 3. Export for evidence / drift tracking
Clear-MobileDevice | Export-Clixml .\MobileDevice-$(Get-Date -Format yyyyMMdd).xml

Syntax

Clear-MobileDevice [-Identity] <MobileDeviceIdParameter>
 [-AccountOnly]
 [-Cancel]
 [-Confirm]
 [-DomainController <Fqdn>]
 [-NotificationEmailAddresses <MultiValuedProperty>]
 [-WhatIf]
 [<CommonParameters>]

Parameters (7)

Parameter	Type	Required	What it controls
-Identity	MobileDeviceIdParameter	yes	The Identity parameter specifies the mobile device that you want to reset. You can use the following values that uniquely identifies the mobile device:
-AccountOnly	SwitchParameter		The AccountOnly switch specifies whether to perform an account-only remote device wipe where only Exchange mailbox data is removed from the device. You don't need to specify a value with this switch.
-Cancel	SwitchParameter		The Cancel switch specifies whether to issue a cancellation request for a pending remote device wipe. You don't need to specify a value with this switch.
-Confirm	SwitchParameter		The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on whether the cmdlet requires confirmation before proceeding.
-DomainController	Fqdn		This parameter is available only in on-premises Exchange.
-NotificationEmailAddresses	MultiValuedProperty		The NotificationEmailAddresses parameter specifies the notification email address for the remote device wipe confirmation. You can specify multiple values separated by commas.
-WhatIf	SwitchParameter		The WhatIf switch shows what the command does without making any changes. You don't need to specify a value with this switch.

Reference facts derived from Microsoft documentation, © Microsoft, licensed CC BY 4.0; restructured with original guidance by serv365.ai.