Commands › Exchange Online

Disable-OutlookAnywhere

Exchange Online ExchangeOnlineManagement Disable-*

Disable Outlook Anywhere on Exchange Server 2010 Client Access servers.

Quick start script

# Disable-OutlookAnywhere — quick start (serv365.ai)
# 1. Connect (app-only shown; interactive: omit the certificate parameters)
Connect-ExchangeOnline -CertificateThumbprint $thumb -AppId $appId -Organization $org

# 2. Capture the current state first — you cannot roll back what you never recorded
$before = Get-OutlookAnywhere
$before | Format-List

# 3. Make the change (dry run first)
Disable-OutlookAnywhere -Identity <VirtualDirectoryIdParameter> -WhatIf
Disable-OutlookAnywhere -Identity <VirtualDirectoryIdParameter>

# 4. Verify and diff
$after = Get-OutlookAnywhere
Compare-Object ($before | Out-String) ($after | Out-String)

Syntax — 2 parameter sets

Identity

Disable-OutlookAnywhere [-Identity] <VirtualDirectoryIdParameter>
 [-Confirm]
 [-DomainController <Fqdn>]
 [-WhatIf]
 [<CommonParameters>]

Server

Disable-OutlookAnywhere [-Server <ServerIdParameter>]
 [-Confirm]
 [-DomainController <Fqdn>]
 [-WhatIf]
 [<CommonParameters>]

Parameters (5)

Parameter	Type	Required	What it controls
-Identity	VirtualDirectoryIdParameter	yes	The Identity parameter specifies the Outlook Anywhere virtual directory that you want to disable. You can use any value that uniquely identifies the virtual directory. For example:
-Confirm	SwitchParameter		The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on whether the cmdlet requires confirmation before proceeding.
-DomainController	Fqdn		The DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory. You identify the domain controller by its fully qualified domain name...
-Server	ServerIdParameter		The Server parameter specifies the Client Access server where you want to run this command. You can use any value that uniquely identifies the server. For example:
-WhatIf	SwitchParameter		The WhatIf switch shows what the command does without making any changes. You don't need to specify a value with this switch.

Reference facts derived from Microsoft documentation, © Microsoft, licensed CC BY 4.0; restructured with original guidance by serv365.ai.