Commands › Exchange Online

Remove-ClientAccessArray

Exchange Online ExchangeOnlineManagement Remove-*

Remove RPC Client Access arrays (load-balanced arrays of Client Access servers within a single Active Directory site).

Quick start script

# Remove-ClientAccessArray — quick start (serv365.ai)
# 1. Connect (app-only shown; interactive: omit the certificate parameters)
Connect-ExchangeOnline -CertificateThumbprint $thumb -AppId $appId -Organization $org

# 2. Capture the current state first — you cannot roll back what you never recorded
$before = Get-ClientAccessArray
$before | Format-List

# 3. Make the change (dry run first)
Remove-ClientAccessArray -Identity <ClientAccessArrayIdParameter> -WhatIf
Remove-ClientAccessArray -Identity <ClientAccessArrayIdParameter>

# 4. Verify and diff
$after = Get-ClientAccessArray
Compare-Object ($before | Out-String) ($after | Out-String)

Syntax

Remove-ClientAccessArray [-Identity] <ClientAccessArrayIdParameter>
 [-Confirm]
 [-DomainController <Fqdn>]
 [-WhatIf]
 [<CommonParameters>]

Parameters (4)

Parameter	Type	Required	What it controls
-Identity	ClientAccessArrayIdParameter	yes	The Identity parameter specifies the Client Access array that you want to remove. You can use these values:
-Confirm	SwitchParameter		The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on whether the cmdlet requires confirmation before proceeding.
-DomainController	Fqdn		The DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory. You identify the domain controller by its fully qualified domain name...
-WhatIf	SwitchParameter		The WhatIf switch shows what the command does without making any changes. You don't need to specify a value with this switch.

Reference facts derived from Microsoft documentation, © Microsoft, licensed CC BY 4.0; restructured with original guidance by serv365.ai.